HC75 versions: 10 different intensification factors
PIN: 20 – 207 bar
PH: 2,000 bar maximum
PRETURN: As low as possible (return pressure to tank)
POUTLET: PH = (PIN – PRETURN) x intensification factor
Mounting: Inline tube
Weight: 2.8 kg.
The HC75 is a compact unit weighing only 2.8 kg. It is ideal for use in a variety of applications where building and maintaining high pressure is required.
The HC75 incorporates a counterbalance valve, which allows fast-forward movement of a cylinder by directing the full inlet flow to pass directly through the booster section until the set pressure has been reached. Then the counterbalance valve opens, and the booster starts oscillating.
The HC75 booster will automatically stall when the high-pressure side H is reached. The booster will continuously compensate for oil consumption to maintain the high pressure. Adjustment of the outlet pressure is carried out by varying the supplied pressure.
An optional orifice can be mounted in the R-port of the booster to prevent overspeeding.
|Max. intensified outlet flow|
|Max. inlet flow|
The basic operation is illustrated in the function diagram. Oil is fed through the directional valve (in the customer system) to the IN port, flowing freely through the internal check valves to the high-pressure side H.
When pump pressure is reached on the high-pressure side H, the internal check valves will close. The end pressure will be achieved by the oscillating pump unit OP. The unit will automatically stall when the high-pressure side H is reached. If a pressure drop on the high-pressure side exists due to consumption or leakage, the OP valve will automatically operate to maintain the end pressure.
Dimension drawing 7-129-02
|Connection||IN / R||H1||H2||H3|
|11||1/4" BSPP||M22 x 1.5||-||-|
|12||1/4" BSPP||M22 x 1.5||9/16-18 UNF||-|
|13||1/4" BSPP||M22 x 1.5||9/16-18 UNF||9/16-18 UNF|
High-pressure adapter ordering codes and specifications are shown in the PDF-file: 7-900-10
Fluids and materials
Additional information is available on the website under Products → General specifications.
Ordering an HC75
Ordering example of an HC75 with i = 13.0, H1 M22 x 1.5 and H2 9/16-18 UNF, DV incorporated and BSPP connections: HC75 – 13.0 – B – 12
High-pressure adapter is required, please specify ordering code – see high-pressure adapter table.
High-pressure adapters will be factory mounted.
Valve pre-setting is required, please specify when ordering the intensifier.
- Select factor
- See flow rate table
- Select type
- A = without DV
- B = with DV
- Select thread
- See table below
|Ordering code||IN / R||H1||H2||H3|
|HC75-___-__-11||1/4" BSPP||M22 x 1.5||-||-|
|HC75-___-__-12||1/4" BSPP||M22 x 1.5||9/16-18 UNF||-|
|HC75-___-__-13||1/4" BSPP||M22 x 1.5||9/16-18 UNF||9/16-18 UNF|
Max. tightening torque BSPP
|IN / R|
|with steel washer||4.0 da/Nm|
|with cutting edge||4.0 da/Nm|