HC9D2 versions: 5 different intensification factors
PIN: 20 – 207 bar
PH: 1,380 bar maximum
PRETURN: As low as possible (return pressure to tank)
POUTLET: PH = (PIN – PRETURN) I (intensification)
The intensification ratio is related to the inlet pressure on media 2, the values in the table are measured at 1 bar on media 2.
Drain connections: Max. 10 bar
Mounting: Inline tube
Weight: 25.0 kg.
A model = no dump valve
Material certificate 3.1 on request
The HC9D2 is a dual media unit which is capable of delivering up to 6.5 l/min flow on the high pressure end. Like other miniBOOSTER models, the HC9D2 raises supplied pressure to a higher outlet pressure and automatically compensates for consumption of oil to maintain the high pressure.
Adjustment of the outlet pressure is carried out by varying the supplied pressure. Relative to its flow capability, the HC9D2 is a compact unit weighing 25 kg.
|Max. intensified outlet flow|
|Max. inlet flow|
The basic operation is illustrated in the function diagram. Media 1 is fed through the IN port flowing freely through the bistable valve BV1 driving the LP pistons. From the suction inlet IN Media 2 is drawn through the check valves 2 x KV1, and pumped through the 2 x KV2 to the high-pressure side H. In this condition maximum flow through the booster is achieved giving a fast-forward function.
The unit will automatically stall when end pressure on high-pressure side H is reached. If a pressure drop on the high-pressure side exists due to consumption or leakage, the HP1 and HP2 units will automatically operate to maintain the end pressure.
Dimension drawing 9D2-120-00
|Connection||IN / R||H1 / H2||S1 / S2||D1 / D2|
|1||1/2" BSPP||M30 x 1.5||1/2" BSPP||1/8" BSPP|
High-pressure adapter ordering codes and specifications are shown in the PDF-file: 6DW-900-02
|Code||Seal material media 1 / 2||Outlet pressure|
|HH||H-PUR / H-PUR||Max 1,380 bar HP|
|HP||H-PUR / PEEK||Max 1,380 bar HP|
|EE||EPDM / EPDM||Max 500 bar HP|
|EP||EPDM / PEEK||Max 1,380 bar HP|
Fluids and materials
Additional information is available on the site General specifications
Ordering an HC9D2
Ordering example of an HC9D2 with i = 5.2, with BSPP connections and H-PUR dynamic seals:
HC9D2 – 5.2 – A – 1HH
High-pressure adapter is required, please specify ordering code – see high-pressure adapter table.
High-pressure adapters will be factory mounted.
- Select factor
- See flow rate table
- Select type
- A = without DV
- Select thread
- 1 = BSPP
- Select seal type
- See dynamic seal table
Max. tightening torque BSPP
|IN / R||S1 / S2||D1 / D2|
|1/2" BSPP||1/2" BSPP||1/8" BSPP|
|with steel washer||13.0 da/Nm||13.0 da/Nm||2.0 da/Nm|
|with aluminium washer||7.0 da/Nm||-||-|
|with cutting edge||13.0 da/Nm||13.0 da/Nm||2.0 da/Nm|